AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
![]() ![]() Reset System(Warm Boot) if you are using vKVM Reboot the appliance by pressing the power switch or select Mount ISO using any one of the mounting options. To overcome this issue, you can connect through CIMC or VGA console.Ĭonnect to the console using one of the options mentioned in Connect to the Console. When you connect Gen 2 and Gen 3 appliances through serial console connection after reboot, there are chances that you mightĮncounter garbled screen display. Installation fails if a USB storage device is connected to the USB port of the appliance as the installer selects the USB ![]() You can verify the Cisco Signature for the ISO image with theĭownload PI-APL-3.10.0.0.205-1-K9.iso, CiscoPI3.10.pem and PI-APL-3.10.0.0.Ĭopy these file to any Linux server and enter the following command.ĬiscoPI3.10.pem -signature PI-APL-3.10.0.0. PI-APL-3.10.0.0.205-1-K9.isoĮnsure no storage devices are connected to the USB port of the appliance before upgrading or installing the ISO image. Network Settings in the CIMC interface and checkĭownload the ISO file PI-APL-3.10.0.0.205-1-K9.iso from and verify file integrity using the checksum values listed for it on. However in case you need to re-image the appliance, you can install the software from the ISO You do not have to perform these steps during the initial The appliance is shipped with the software version pre-installed. ![]()
0 Comments
Read More
Leave a Reply. |